Results 1 to 14 of 14
  1. #1
    rchalker's Avatar
    Join Date
    Dec 2010
    Location
    Youngstown, Ohio, USA
    Posts
    6,790

    Furnace Trouble Day One

    Well, its the first day of the year and I woke up this morning with it being -2F outside and 54F inside the house. Here I was working on the furnace at 4:30AM. I just had this 96% efficiency furnace put in so I was surprised to see it not working. I took the service panel off to see if I had a code. After getting the code I tested the said sensor only to find it working properly. Would you believe the problem turned out to be the return from outside. I found it full of snow from being sucked into it. With the temperatures being so cold lately, the ice in the PVC just couldnt thaw. So if you have a high efficiency furnace with both a vent and return from outside, check the PVC pipes for blockage first. That might just save you a service call.
    AKA: Rodney _______ Detectors Used:
    ___________________White's Spectra V3i with DX-1
    ___________________White's TreasurePro
    ___________________Bounty Hunter Discovery 3300



  2. #2

    Join Date
    Jun 2009
    Location
    Lagrange,oh
    Posts
    403
    Glad you figured that out and will keep the info in mind since I am getting a new furnace put in this summer

  3. #3
    Eastcoastdigs's Avatar
    Join Date
    Apr 2017
    Location
    NY to MD
    Posts
    720
    Glad you were able to find a simple solution before you froze and without having to call in an HVAC tech. And now your experience may benefit others if they have a similar issue.

  4. #4
    rchalker's Avatar
    Join Date
    Dec 2010
    Location
    Youngstown, Ohio, USA
    Posts
    6,790
    I turned on the gas logs upstairs and downstairs right away after getting up. They are 60,000 and 45,000 BTU's so it didn’t take long to heat the house while I figured the problem out. I’m just glad I didn’t have to call someone out to only unblock a pipe. What a waste of money that would have been.
    AKA: Rodney _______ Detectors Used:
    ___________________White's Spectra V3i with DX-1
    ___________________White's TreasurePro
    ___________________Bounty Hunter Discovery 3300



  5. #5

    Join Date
    Oct 2011
    Location
    Eastern Iowa
    Posts
    311
    It was a record-23 below this morning! And 6 inches of snow on Friday.I noticed
    Comin home from a friend's party this am that an icicle was up to the top of the inlet or outlet pipe for the furnace. I btr go knock it down. Glad yur warm again!!! I had a few times comin home from work a few years ago and it was 50 degrees in here. I had a friend put a new thermostat in as i had an old dial mercury 1 still. It worked perfect after that

  6. #6
    deolslyfox's Avatar
    Join Date
    Jul 2008
    Location
    Central Florida
    Posts
    47,593
    Thanks for sharing that info !! Definitely a "good to know" !! Hope it warms up for you !! It is supposed to dip into the 30's overnight .... That is craziness for Florida !!

    Raining right now. Supposed to rain tomorrow as well .... Could be worse ....

    Everyone stay warm and stay safe !!
    If there's anything I hate worse than diggin' pulltabs, its missin' a gold ring.

  7. #7

    Join Date
    Nov 2017
    Location
    Wyoming
    Posts
    14
    Rodney, I have one of the high efficiency furnaces with the horizontal PVC vent & return pipes also. During the winters here, I have to constantly watch those pipes to make sure they don't get covered in snow. The vent pipe constantly drips condensation and it builds up a huge icicle from the ground up. It would eventually block the vent pipe if not removed. They are more efficient, but require more vigilance.

  8. #8
    rchalker's Avatar
    Join Date
    Dec 2010
    Location
    Youngstown, Ohio, USA
    Posts
    6,790
    Quote Originally Posted by Highspade View Post
    Rodney, I have one of the high efficiency furnaces with the horizontal PVC vent & return pipes also. During the winters here, I have to constantly watch those pipes to make sure they don't get covered in snow. The vent pipe constantly drips condensation and it builds up a huge icicle from the ground up. It would eventually block the vent pipe if not removed. They are more efficient, but require more vigilance.
    I love the efficiency of this furnace. It dropped my gas bill approximately $60 a month when the temperatures are in and below the teens. It would be nice if the owners manual said something about these pipes freezing up. Not everybody is as technical and mechanically inclined as myself. I fix the problem with a piece of heavy cable and a bucket of very hot water. I just let water run over the outside of the inlet pipe until the ice melted enough to poke it out. Not a difficult problem to fix but I’m sure most people make a service call. I hate to say it but I’m sure crooked technicians make money on people when it’s really a simple fix.
    AKA: Rodney _______ Detectors Used:
    ___________________White's Spectra V3i with DX-1
    ___________________White's TreasurePro
    ___________________Bounty Hunter Discovery 3300



  9. #9

    Join Date
    Jan 2012
    Posts
    1,342
    The "fix" sounds simple enough, except when you take into account you were doing this at 0430 at -2. Sounds like a heck of a way to bring in the new year. But you got it done and know what to watch out for so it doesn't happen again. LTD

  10. #10
    bassplugger's Avatar
    Join Date
    Dec 2010
    Location
    foothills of NC
    Posts
    6,485
    .good you didn't have any frozen pipes to contend with on top of no heat. I just walk down to the basement and throw a stick of wood or two into my waterstove and it keeps the 500 gallons of water at around 200 degrees and that heats my 3000 sq ft house and my 2900 sq ft shop plus all the hot water to wash clothes and take showers and even wash cars with hot water if you want.. Only draw back is you have to enjoy cutting, hauling and stacking firewood. Wind chill here is 7 and temp is 16 outside, but toasty 72 inside
    If the bass ain't biting, I'm scratchin for silver

  11. #11
    donpie's Avatar
    Join Date
    Mar 2017
    Location
    Cleveland, Ohio
    Posts
    200
    I haven't been on the forum for a while, so I just read your post. Hope you wont have this problem again since we are supposed to get hit by a bad storm in the next 24 hours.
    Bogdan "Don" Pieniak

  12. #12
    rchalker's Avatar
    Join Date
    Dec 2010
    Location
    Youngstown, Ohio, USA
    Posts
    6,790
    Yeah, 4-8 inches coming soon. I’m not to excited about it. My back has been killing me this winter. I can’t wait for spring. I’m thinking about getting another nerve block. I’m about to go nuts because of the pain I’m in. I think on a scale 1-10, I’m at a 9 right now. There’s days I think I’m going to have a nervous break down. I just don’t know what to do to stop the pain.
    AKA: Rodney _______ Detectors Used:
    ___________________White's Spectra V3i with DX-1
    ___________________White's TreasurePro
    ___________________Bounty Hunter Discovery 3300



  13. #13
    donpie's Avatar
    Join Date
    Mar 2017
    Location
    Cleveland, Ohio
    Posts
    200
    I feel for you Rod! I'm sure you are doing everything you can to decrease the pain. Surgery is always a risk and a crap shoot. Drugs can be dangerous but sometimes effective, unfortunately with this opioid crisis doctors do not want to prescribe drugs to people who really need them. I don't know who has the answers just keep plugging away and pray for more days that are better than days that are bad.
    Bogdan "Don" Pieniak

  14. #14
    bassplugger's Avatar
    Join Date
    Dec 2010
    Location
    foothills of NC
    Posts
    6,485
    So sorry that you are having such painful wintery days--I have a younger sister that is constantly fighting back pain from an injury while working in the intensive care unit at a hospital, even after surgery she still has to stay on medication-- I can't say I know how you feel but I know someone that does--Hope and pray you can find some relief
    If the bass ain't biting, I'm scratchin for silver

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Log in

Log in