White's Featured Customer Stories
A golden whale of a story Maryland militia buckle Patience and imagination2 Most Call It Junk .. I Call It Treasure MXT All Pro

Results 1 to 3 of 3

Thread: Toggle Control Replacement Help

  1. #1

    Toggle Control Replacement Help

    Hey everyone,
    We have a White's Classic ID, ProScan 800. We ordered a replacement Toggle switch because the old one wasn't working. I've looked at the Manual and checked everywhere but we can't figure out the correct wire placement when replacing it. Does anyone have a picture of what yours looks like or instructions for replacing it? We'd love to get it back together and be out hunting.
    Thanks!

  2. #2
    Super Moderator deolslyfox's Avatar
    Join Date
    Jul 2008
    Location
    Central Florida
    Posts
    41,672
    Detectors
    V3i / VX3 / DFX / MXT Pro / M6 / 6T / CM GT / XLT / BH 300 / SURF PI DF / IDX Pro / 6000D S2
    Hook it up just like the one that is in there !! Mark the wires or switch them one at a time ...
    Last edited by deolslyfox; 08-19-2013 at 04:41 AM.
    If there's anything I hate worse than diggin' pulltabs, its missin' a gold ring.

  3. #3
    Platinum Member Aluminator's Avatar
    Join Date
    Jan 2008
    Location
    Mason County, WV
    Posts
    2,270
    Detectors
    Me: TDI, DFX, XLT, XL Pro, BHID 300, Surf P.I. (Plus), 6000 Di Pro (blue box)
    I'm guessing it's too late for that...

    You should have three wires to the toggle switch. Most likely black, grey, and blue. The black goes to the front the grey in the center, and the blue on the back terminal lug of the switch. Hope this helps.
    "To do is to be" - Nietzche
    "To be is to do" - Kant
    "Do Be Do Be Do" - Scooby Doo

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •